The surplus stone of the cut out amethyst is a relatively good shape. If you zoom in with a loupe, it may be a little chipped, but it is recommended...
300円
Add:
This is a failed work. The stone itself has a large inclusion, which may break, A stone polished while thinking that it will break from cracks when...
500円
Add:
The side girdle is not horizontal but slightly offset. The surface table is wider than the appropriate size. All of them are small gaps that can be...
500円
Add:
The side girdle is not horizontal but slightly offset. The center is slightly off. All of them are small gaps that can be magnified and checked with...
500円
Add:
This is the type of loose loose gemstone necklace. Here, emphasis is placed on the shape of the rough, and only the sides are cut into octagons. The...
2,500円
Add:
The amethyst comes out in a hexagonal crystal at the time of mining. If it is formed naturally, it is somewhat distorted. It is in the state where...
2,500円
Add:
Because of the inclusion and the stone material was not very good, it is an amethyst with a noticeable roughness. I made it on the assumption that it...
300円
Add:
If you make a ring with a large grain, it looks quite large. The center is not well established in the production, and there are gaps in the table...
500円
Add:
The upper star facet, which is usually produced in two layers, is tripled to make it more bright. The degree of perfection is also excellent....
8,000円
Add:
This is the type of loose loose gemstone necklace. To be honest, there were a lot of inclusions, and for some reason I couldn't finish the production...
500円
Add: